| |
| |
| |
 |
ChipTorque's XFlash2 Euro Tuner is supplied with up to three aftermarket tunes. These can be customised to the use of different fuel types, boost levels, rev limits or modifications to provide greater variety for the user.
The plug-in installation process means that no physical modification is made to the vehicle and alternating between the factory and preset tunes can be done unlimited times. User friendly installation means that tunes are easily alternated between in less than 5 minutes by connecting the XFlash2 to the vehicle's OBDII port and using the product yourself. The XFlash2 is fully reprogrammable should you require a retune to suit further modifications or a complete new vehicle. |
This product can only be used on one vehicle at a time however it can even be uninstalled from the vehicle, which reflashes the vehicle back to its standard tune. Once unlocked, the XFlash2 can then be installed on another compatible vehicle (accurate tunes may be required for other vehicle models).
With full control of the factory engine management system ChipTorque's experienced tuners can adjust many parameters including fuel, timing, variable cam timing, idle, limiters including speed and revs. This can be provided with off the shelf ChipTorque tunes to suit your vehicle's modification or combined with a custom dyno tune at our Gold Coast premises to allow us to fine tune your vehicle for maximum results. |
 Download Installation Instructions
Download an Order Form |
|
|
|
XFlash2
Euro Tuner Kit |
XFlash2 Euro Tuner
Plug-in device that flashes a ChipTorque aftermarket tune into the factory ECU via the factory OBD-II diagnostic port. Retains the factory tune and can store up to three aftermarket tunes. The product stays with the vehicle so the user can alternate between stored tunes. |
Cables
Supplied with OBDII cable. |
Tune Set
Tune sets supplied with an XFlash Euro Tuner unit consist of up to 3 tunes. |
$1100
|
Optional Extras
XFlash2 Euro Tuner - $880
XFlash2 Euro Tuner hardware only. Not supplied with tune sets. |
No two cars are the same...
To get the most from your car we recommend a custom tune. Average tuning time is about 4 hours but more time may be required depending on your modifications.
Our custom 2WD dyno rate is $250/hr
|
Note: Freight, Installation and Dyno Tuning are additional. Prices subject to change without notice. All prices are recommended retail price in Australian Dollars. All prices are GST inclusive. |
| |
|
|
|
|
